CompuSTAR CM6300 Guia de Instalação descarregar pdf (Página 17)

Connector 7 (CN7), 4-Pin to 4-Pin or 6-Pin (Pre-wired Antenna Cable)

Connect your antenna cable to this port. You can only use 4 to 4 pin or 4 to 6 pin antenna cables. 6 to 6

Pin antenna cables do not work. Do not use both Connector 7 and Connector 8 at the same time.

Pin 1 Yellow - RX input. This wire receives the signal from remote.

Pin 2 White - TX output. This wire transmits the signal to remote.

Pin 3 Red – Constant 12V positive (+) output.

Pin 4 Black – Negative (-) ground.

Connector 8 (CN8), 6-Pin to 6-Pin (Pre-wired Antenna Cable)

Connect your antenna cable to this port. You can only use 6 to 6 pin antenna cables. 4 to 4 or 4 to 6 Pin

antenna cables do not work. Do not use both Connector 9 and Connector 10 at the same time.

Connector 9 (CN9), 2-Pin (Pre-wired Thermister)

Plug optional thermister into this connector to monitor the vehicle’s temperature. It is used to display

temperature on two-way LCD’s. To use Timer Start features review Option Group 2. IMPORTANT: New

Thermister plugs are blue 2 pin connectors on the CM6 series but old white plug Thermisters will still work.

Pin 1 Black - Thermister

Pin 2 Black/White - Thermister

Connector 10 (CN10), 3-Pin (Pre-wired Valet/Programming Switch)

Pin 1 Gray/Black - Negative (-) ground.

Pin 2 Gray – 3V positive (+) L.E.D. output.

Pin 3 Gray – Negative (-) output.

CM6300 Install Guide

Alarm System

www.firstechonline.com | www.compustar.com

Page 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 30 31

Sem comentários

CompuSTAR CM6300 Guia de Instalação Página 17