By Firstech, LLC 20 21 By Firstech, LLC
General System Functions
Press button (II) for 2.5 seconds to remote start an automatic transmission vehicle. If you are in range and if the vehicle is ready to remote start, the
remote will beep once and the CompuGLO backlight will light up to indicate that the remote start command has been successfully transmitted.
If you are in range and the remote beeps three times, there is a remote start error. Refer to the remote start error diagnostic on the last page of this
manual for details.
Upon receiving confirmation that your vehicle is running, the LCD will flash the exhaust icon and the clock icon will begin to show the
amount of run-time remaining. The remote start run-time can be programmed for 15, 25, 45 or 3 minutes - ask your local Nustart
dealer to adjust Option 2-7 if you would like a run-time other than 15 minutes (default).
IMPORTANT: Your vehicle s key must be inserted into the ignition and turned to the on position prior to driving your vehicle. If the foot brake
is depressed prior to the key being in the on position, the vehicle will shut off.
In order to remote start a manual transmission vehicle, the system must first be set in Reservation Mode. Reservation Mode must be set each and
every time you want to remote start a manual transmission vehicle. The purpose of Reservation Mode is to leave the transmission in neutral before
exiting the vehicle.
IMPORTANT
The transmission must be left in the neutral position. The vehicles windows must be rolled up.
The vehicles door pins must be in working order. Do not set reservation mode or remote start with people in the vehicle.
Do not install this remote start on a manual transmission vehicle that has a convertible or removable top.
a@t@r@s@f
m@t@r@s@f@Hr@mI
General System Functions
Activating Reservation Mode
STEP1 : While the vehicle is running, place the transmission in neutral, set the emergency / parking brake, and remove pressure from the foot brake.
STEP2 : Remove the key from the vehicle’s ignition. The vehicle’s engine should remain running even after the key has been removed. If the
vehicle does not remain running visit your local authorized NuStart dealer for service.
STEP3 : Exit the vehicle and close the door. The vehicle’s engine should shut off within 10 seconds upon closing the last door. If the vehicle’s engine
does not shut off, your door trigger may be functioning improperly. Do not use the remote start feature and take your vehicle to a local
authorized NuStart dealer for service.
Once the vehicle shuts off your system is in reservation mode and the vehicle is ready to safely remote start.
IMPORTANT : By default, the system will lock/arm the vehicle upon setting reservation mode. Take care to not lock your keys inside the vehicle.
Cancelling Reservation Mode
Reservation mode will be cancelled for the following reasons;
You did not activate the parking brake prior to turning off the ignition. You pressed the foot brake after the key was removed from the ignition.
You released the parking brake after the key was removed from the ignition.
You entered valet mode, opened the vehicles door, hood, trunk or set off the alarm.
Reservation Mode Settings
Reservation mode settings can be programmed with Option 1-6. It is recommended that reservation mode settings are programmed by your local
authorized NuStart dealer.
Default1 : Locks doors when reservation mode is set.
Option2 : Does not lock doors when reservation mode is set.
Option3 : Reservation mode sets 10 seconds after the last door is closed, as opposed to immediately.
This option will allow you to access the vehicles rear doors, trunk or hatch prior to the system setting reservation and passively locking/arming.
Comentários a estes Manuais